Hi, I’m Chris Tavano for Tundra Restaurant
Supply. In today’s episode I’m going to show you
how to change your blade assembly for your Nemco Tomato Slicer. First you’re going to need a crescent wrench To loosen up the nuts on the side of your
blade assembly. Lefty-loosey, righty-tighty. Then once you’ve got those bolts out the
blade assembly won’t come out quite yet. You’re going to loosen up the wing nuts
on the side of the cutting board So we can get our pusher block assembly off. From there your entire block assembly should
slide out. Now be careful. The sharp parts of the blade are facing the
inside of towards the pusher block itself. We want to take that one out. Get your new blade assembly. One thing to keep in mind is the distance
of the holes from the base of the hinge assembly itself. The smaller distance should be going on the
bottom. Again, remember just look closely and you
can see the beveled edge of your actual blade. That’s going to be facing away from you
towards the Brand name. It slides right in. We’re going to grab your pusher block again
and notice that there are grooves And that’s going to slide right in to the
groove of the cutting board. Gently slide it into place. Once you’ve got it in all the way we can
go ahead and get our bolts right back in the side. Here you can see as I’m screwing in through
the unit itself The bolt is actually securing itself into
the blade assembly. For this stage you need to get them finger
tight. Then you can get your crescent wrench and
be sure we screw righty-tighty. The last piece you’re going to need Is your end cap for the cutting board to go
back in place So your pusher block doesn’t come off. It’s pretty easy. It only goes in one way. That’s how you replace your blade assembly
for a Nemco Easy Tomato Slicer. Watch your fingers! If you have any other ideas for do-it-yourself
videos please comment below!